Here I created a Magic / Wizard Tonie Puck to turn a Creative Tonie into a Magic Puck.

You can remove the RFID chip and the 2 magnets from the Creative Tonie and install them in this printed puck to get a neutral Magic Tonie. Instructions for this can be found on the internet, or alternatively, you can simply slice open the Creative Tonie until you have obtained the necessary components. The RFID chip is usually located behind the Tonie's face.

The printed puck has a surface area of 35mm, so you can naturally stick printed or purchased figures on it afterward to personalize it and then provide it with an audio file of up to 90 minutes.

You will find 2 different print profiles, where the 1st has an automatic pause set so that you can insert the components and then resume printing.

For Profile No. 2, you will receive a lid to insert the components afterward and then glue them.