Design Concept

The Hygrometer Holder is created to securely attach a standard hygrometer to a Multiboard system, allowing for optimal monitoring of environmental conditions.

This is a remix.  The original was made by MG Prints over at Makerworld.  (Link at the bottom of this page).

I printed the original, but it was too tight. My hygrometer came apart when I tried to remove it from the holder, so I made some changes...

Changes

Changed the overall shape to give it slightly more round look,

Increased the diameter,

Cut 5mm from the total depth.

Printing Advice

Print with PLA

0.20mm Layer Height

10% Rectilinear Infill

Tree support needed

Assembly Instructions

The holder can be used with or without the Multiboard Snap depending on your setup.  I included a single Multiboard Snap as an STL.

If you find this remix useful in any way, please leave me a LIKE.  Happy Printing!