Shoe Horn
TameWall
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
17
13
0
게시일:2026-01-16 00:20:20
3
0
17130설명
태그
모델 소스
리뷰(0)
This shoe horn is a slight remix of "Big Shoe Horn" by ecoiras over on *********** (thing:4719283). I wanted something functional to try out this Hyper PC filament I have so this was it.
This shoe horn is pretty big. It can be printed on its side with almost no supports. I used tree supports which hold up the hole part, and the slight angle on the print bed side. I used PC filament, but you could probably get away with using PETG, and possibly PLA since it's a sideways print.
If you do use PC to print this, I recommend using a deburring tool on the sides because at .28mm the sides are a bit rough right off the printer.
태그
모델 소스
원본 링크: 자세히 보기
CC BY