My inhaler wouldn't stop falling over. So I cut the bottom of my inhaler into a gridfinity block. Created to be compatible specifically with Breyna's annoying molding (budesonide and formoterol fumarate dihydrate for anyone else who uses the chemical name). Also works with a generic albuterol inhaler.

Maybe you'll find this useful too.

     The inhaler component should be a negative part. Make the negative rectangular box slightly wider to make it easier to slide out the inhaler. At default size, I have to take off the cap of the breyna to remove it, but that is useful to stop my inhaler from becoming a cat toy. The albuterol inhaler slides out easily as it isn't a perfect fit but it also works.

Print Suggestions

• PLA

• Gyroid Infill at 7-15% density (15% is unnecessary but my default density, so I tested that first.)

• Magnets are optional