Robotics Car Chasis
GentleRod
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2025-09-16 03:48:11
1
0
000설명
태그
모델 소스
리뷰(0)
This is a 3D-printed robotics car chassis with mecanum wheels, designed for makers, hobbyists, and students who want to build smart robotic vehicles.
The chassis supports Arduino, ESP32, and Raspberry Pi controllers, making it suitable for projects such as:
Obstacle avoidance cars (with ultrasonic sensors).
Remote control cars (Bluetooth/Wi-Fi).
Line-following robots.
AI-driven cars with computer vision.
Features
Omni-directional movement with 4 mecanum wheels.
Battery compartment for 2× 18650 cells.
Mounting slots for motor drivers (e.g., L298N).
Front cutouts for ultrasonic distance sensors.
Top section for breadboard or controller boards.
Recommended Print Settings
Material: PLA or PETG
Layer Height: 0.2 mm
Infill: 15% - 30% (For strength)
Supports: None
Bed Adhesion: Brim recommended
📄 Full assembly and usage instructions are included in the attached PDF.
The chassis supports Arduino, ESP32, and Raspberry Pi controllers, making it suitable for projects such as:
Obstacle avoidance cars (with ultrasonic sensors).
Remote control cars (Bluetooth/Wi-Fi).
Line-following robots.
AI-driven cars with computer vision.
Features
Omni-directional movement with 4 mecanum wheels.
Battery compartment for 2× 18650 cells.
Mounting slots for motor drivers (e.g., L298N).
Front cutouts for ultrasonic distance sensors.
Top section for breadboard or controller boards.
Recommended Print Settings
Material: PLA or PETG
Layer Height: 0.2 mm
Infill: 15% - 30% (For strength)
Supports: None
Bed Adhesion: Brim recommended
📄 Full assembly and usage instructions are included in the attached PDF.
Leave you suggestions down below for me to improve and fix.
The Flaws are: Breadboard cutout is too small.
태그
모델 소스
원본 링크: 자세히 보기
CC BY