Purpose

Designed to securely hold square coasters, this holder keeps them organized and accessible.

It can hold up to six coasters 95mm square x 3mm thick. I will use it with the wooden coaster that I make.

Printing Suggestions

• I recommend using PLA or a wood-fill filament for texture enhancement. I used Creality PLA wood light pine.
• Print with a layer height of 0.16 mm for a balance between quality and speed.
• Consider using a brim and glue to prevent the base from warping during the print.

Assembly Instructions

The holder, which is printed in one piece, does not require assembly.

The last photograph is a sample of Creality PLA wood, half of which I stained to match the wood of the coasters, but as expected, it wasn't successful as the stain only slightly darkened the PLA wood.