Summary

Freddy_Chiky had an AWESOME design that covered the whole intake, I used his design for a while but it was a bit too long for my 20 long. So then i super glued the strainer piece higher and covered it in foam but I didn't love the look. I decided to go ahead and add a retaining area on the bottom to add foam, so it can be easily removed, replaced. I wanted to be able to just cut a rectangle from the foam sheet I have laying around.

It gives it a bit more depth which is a common complaint with the 35, and maintains the square aesthetic.

I printed this with PLA+ in black eSun brand. 20% infill. I used tree supports. Removing them was a bit of a chore on the grid portion but it looks fine once they're cleaned up.