Project: nutcraker.hfp

I have a license for this image.

I pasted two snap magnets on the back.

Print with a layer height of 0.08 mm, a base layer height of 0.16 mm, and a 100% fill rate

The model size is 120x120mm.
You can use a higher layer height for printing at a minimum depth of 0.48 mm or less
The maximum depth is 2.2mm, and the actual depth is 2.3mm.

Consumables used:
BambuLab black PLA, transmission distance: 0.3
BambuLab basic blue-grey PLA, transmission distance: 3
Geeetech grey PLA, transmission distance: 1
BambuLab Basic Ivory White PLA, transmission distance: 5
This printer uses four unique consumables

Replacement instructions:
Start with black
Switch to blue-gray at the 8th layer
Switch to gray at the 16th layer
Switch to jade white at the 18th layer