Going through my electronics parts i was in need for a couple of rf chokes unfortunately i had nothing to use. So I designed the body for a rf choke that i could wing coils on. I added a cutoff tab that would fit my drill. I uploaded with and without the tab to fit the drill for hand wind. Once the coils wound you can cut at the cut off area to find a small hole to insert the wire for connecting. After its completed and checked with a multi-meter to assure connection, you can cover it with uv resin. (((Warning))) Its pretty tricky to print.

Other

mk3

No

No

.05-.10

20%

I would suggest playing with the temperature, too hot you have a blob too cold the layers will not stick. There is a happy medium just tricky to find.