Summary

This is a remix of JGabriel88's wall mount for the Martin Backpacker guitar. It uses the strap peg at the base of the neck to hold it; a cool solution he came up with.

I deepened the cut which holds the peg to make it more secure. I also added an extra screwhole and recessed it and added some hole caps to cover the screws after mounting. I added wings which hug the heel of the guitar to stabilize it from swinging side to side or hanging off-kilter -- not something that typically happens but if you leave a strap attached to the bottom or a capo somewhere, it could make it hang weirdly. If you don't need those, you can delete them from the model and it will be a modest improvement over the original.

I included my 3mf files created in Orca/Bambu. I recommend using a very mild Fuzzy Skin on the mount for aesthetics. The hole cap has to be high quality print and should use the Arachne wall generator to print the thin lip that goes into the screwholes. Infill etc are up to you!