A slide in case for the Teenage Engineering OP-Z.
This is in two parts for easy stable printing which are easily joined with CA glue.
The OP-Z slides in and can be held securely using a long rubber band. There are grooves to hold the band in place.
The OP-Z on-off-volume control is protected and the open end allows the OP-Z to be charged while in the case.
I suggest printing these with edges to be glued are top to avoid any elephant's foot bulge being evident after gluing.
In my experience, CA glue will provide a perfect, near invisible and strong bond.

No

No

0.16 Layer Height

15%

PLA