Project: Deadly Cigar.hfp
Print with a 100% fill rate, a layer height of 0.08mm, and a base layer height of 0.16mm.

The model's dimensions are 117.28x150mm.
You can print with a higher layer height at a minimum depth of 0.48 mm or less
The maximum depth is 2.2mm, and the actual depth is 2.3mm.

The filament used:
PLA PolyLite, black. Transmission distance: 0.3
PLA BambuLab Basic Red. Transmission distance: 4
PLA BambuLab Basic Yellow. Transmission distance: 6
PLA PolyLite, white. Transmission distance: 5

This print uses four unique filament materials

Replacement instructions:
Starting with black
Replace it with red on the 8th layer
Replace it with yellow on the 13th layer
Replace it with white on the 20th layer