I needed a small shim to stop my old windows from rattling, but this could be scaled up for anything.

MiniShim_v1 : The end comes to a sharp point. When printing at .2mm that small end is a bit thin and tends to break off, but if you're scaling this up that may be ok.

MiniShim_v2 : The end has been trimmed to 0.4mm height for better structure at the default size.

Width: 10mm
Length (Ramp): 32mm (Approx.)
Height (Ramp): 3.5mm (Approx.)

The length and height of the ramp are taken right up to where it starts to curve up for the tab.

Creality

Ender-3 S1 Pro

No

No

0.2mm

Any