This is a tissue box holder to hold normal sized tissue boxes;

-There is 2 wall mounting options available;
-Recess hole to fit double sided tape.
-Four screw holes.

-The bracket clips in the wall mounts by the 2 small holes.

-There is 2 big holes on each brackets to fit;
-The middle part to keep the 2 brackets at the perfect distance.
-Side clamps to keep the box from going side to side and up when you take tissues out.

-The side clamps v2 can hold a rubber band if you need to keep the top of the clamps at the right distance.

Print settings;

infill /support /orientation
-Wall mounts (both type) -­­> 20-25% / yes / print them on the sides so the tabs can't break because of the layers
-Brackets -> 15% / no / print them flat
-side clamps -> 15% / no / print them on the sides so the tabs can't break because of the layers (you can either print 4 or 2 if you use the middle part)
-Middle part -> 10% / no / print it on its side (thin part touching the build plate), i had to put it at 45 degrees to fit it on a 220 x 220 build plate

ELEGOO

ELEGOO NEPTUNE 3 Pro

Doesn't Matter

Yes

normal (0.16)

in description

The first version of the side clamps didn't have any way to hold a rubber band. Thats why I made a v2 that has 3 slots at 3 different heights to make it tighter or looser.