This is for use with the LDA1001 Tweeter. This provides the base which is screwed onto the open end of the tweeter to support any of the published rear diffusers below:

• Cone
• 35 Degree Angled

You will need to purchase the 6x3mm rare earth magnets separately. Watch the video for instructions on how to add the magnets to the printed component. You can use CA glue to adhere the magnets to the print. Allow 15 minutes to dry before attempting to attach to the driver.

If you don't have a 3D printer, you can get any of these components printed by a 3rd party like Craft Cloud.