A drill holder for your electric drill/screwdriver, featuring a spare belt hook screw. It can hold up to 5 standard drill bits using magnetic force!

After printing is completed, just press the magnets in. They are quite tight and may require some force to push them in.

This is suitable for a screwdriverOn the right sideFor the left side, you just need to mirror it before slicing it.

You will need:

• 5 neodymium magnets with a diameter of 5 mm and a height of 2 mm.
• 1 installation screw.
  • For my Makita, I used M4x20 screws, which are a bit too long. It would be better to use 18-mm screws, but you'll need to cut the screws shorter.
  • For Dewalt, I believe they use M3 screws, but please check your own tools.