Quick and dirty LED Ring cover to stop the constant red ring of the mute button on the Amazon Echo 2nd Gen as it can't be switched off.

Printed in PLA on a CoreOne. 

I printed with 0.2mm first layer then a 0.08mm layer height on structural, for a nicer angle and radius's on edges. Part uses about 3/4g of filament

Dont see why 0.2mm full height wouldnt work. The finish of the edges might not be as clean.

Can sit hard against the top face, or lift it off a 2 or 3mm for some airflow if you're worried about heat from the LED. (As shown in the pictures) don't see why it should get overly hot. If i find it's getting too hot i'll make some vents.