My wife had bought this countertop Dixie cup dispenser but decided it needed to be wall mounted. I designed a mount that could be CA glued to the side and then used 3M mounting tape to attach it to the wall. The exposed top opening was unsightly so I made a cap to cover it.

The cap was printed in 2 pieces. The main body was printed top-side down and the handle was printed separately. Using a piece of filament as a centering guide the handle was CA glued to the top.

NOTE - This set-up is to use 3oz cups. By flipping the dispenser over it will accommodate 5oz cups but the lid will not then fit.