The images show the previous version of this case, but the newest files exist here, the only difference being a bezel on the screen so that you can see more easily. Also excuse the bad print quality, it's glow in the dark filament, prints awfully and it's the only 'working' filament I had at the time. Enjoy this case!

WAIT! There's more...
The bottom of this case looks like an old Nintendo Game (super/64) so one day I'll bother to make a plug-able attachment into which it will slot.

WAIT! There isn't more...

:(

Anet A8

Doesn't Matter

No

You probably know what you're doing! (0.2mm)

100% (Might as well since there aren't any gaps at all)

The dimensions aren't fantastic and i'm new to CAD.

Disclaimer---------:
I am not responsible for any wasted filament you have used to print this or if you get hurt.

A useful TIP:

Sand down button extensions until they work, trim reset button extender base and drill out holes until they work (should be 4mm for A and B buttons and 3mm for the RESET) if this doesn't work use a bigger drill bit, but not too big. Don't Exceed 4.5MM