Remix of https://www.thingiverse.com/thing:6612556 made by MrDeath_X1

• "Arms" removed compared to original design

• Redesigned to be printed in TPU in mind.

• The little "slot" at the top should be able to slide into the Omega red dot and hopefully the cover will not move. (And some black tape could be added if needed, still keeping the "no arm" design).

• Re uploaded the original template for cutting the polycarbonate just in case. (Made no change compated to the original)

• Printed in TPU (hopefully this will absorb bbs impact)

• Printed "flat" on the printer bed

• No support (was just OK even for the groove with my printer) (You may add support if required for you)

• 8 bottom layers (hopefully this will absorb bbs impact)

• 4 top layers

• 4 walls

• 20% infill (Cubic Sub.)

• 12 g / 4.13m TPU

• ~ 1h30 print