I loved yoni's modular dish dryer, but I was holding only some reusable (straw wheat) plastic plates, so I didn't need the arms to be that strong and they were pushing on the bottoms of the plates leaning them more forward than they needed to be. I sliced the ends down to save on plastic and printing time. As you can see, I printed several of the long ones before deciding to shorten them, so I ended up having them face each other so the short side is on the back and the long is between the plate fronts. No sense in throwing out the long ones when they can still work. There are close ups of the old and new dish dryer versions on the back of the purple plate. These are all the "basic" length, I just don't snap them together all the way if I need more room.

Also, I was having an issue with the foot of the cutlery dryer missing pieces, so I remade those snap bottoms. Note that the cutlery dryer is very small, I'd actually prefer it be wider and on top of the feet instead of between them, but this works ok as is. I did not need the glass stand.