A simple and convenient way to display Cinderwing and other dragons in the 3DP supplier booth. It is ideal for grid walls and many other types of hanging walls/display stands. Version 2 does not require screws and is connected via a short piece of consumables. For assembly instructions, please refer to the following section.

Note: Do not use PLA. If you use PLA for printing, the clamp will not work properly.I willDeformation/breakage. I recommend PETG or ASA.

Assembly:

There are two methods of assembly: crimping and welding. Welded connections may be stronger, but depending on your usage, crimping may also be a suitable method.

Splice method: Pass the consumables through the groove, splice the other side, pull it back until it is flush, and then cut off the excess parts.

Welding method: Pass the consumables through the grooves, leaving about 0.5 to 1.0 mm on each side, and then use a soldering iron to flatten the excess parts. A flat-tip soldering iron works best.