Tiny generic pawn like figure; created for use with D&D maps, as my group cannot always print our maps to the correct grid size. dimension are: diameter 5mm x height 10mm Our maps are typically kept on a metal sheet, so I added a 2.1mm cavity in the base to insert some tiny 2mm diameter 1mm height disk magnets. I am still testing print settings but I have tried FDM with a few PLA choices. While the pieces print well at 0.1 layer height, the tolerances were not tuned well enough for the magentic disks to fit and the pieces are too small to clear out the cavity with the tools I have on hand. I am going to test SLA for these asap.