This is a replacement part for the plastic wing-nut with threaded insert that is used to adjust the position of the handle for RYOBI 40-Volt Jet Fan Blower.

Instructions:

1. Remove the threaded insert from the old-broken plastic bolt. I used a knife and whittled away the soft-plastic until the insert was completely removed.
2. Print this part lying down on the bed. You want the layer-lines parallel to the shaft of the bolt.
3. Use a 5/16" drill-bit to clean out the pocket so the threaded insert fits snuggly inside.
4. Use a dab of superglue to attach the threaded insert into the pocket of the newly printed bolt.
5. Install and enjoy!

Please note, I printed with PLA -- it is not as strong as the original part, so don't crank down on the wing-nut super hard. Consider printing with stronger materials.

Creality

Ender 3

Yes

Yes

0.2

25%

Print laying down on the bed!