Print twice to obtain a complete mold. For larger models, it is highly recommended to use a larger nozzle size. It is best to print with PETG material, use 100% of the edge

I printed my mold using 0.8 nm and a layer height of 0.55 mm.

For wet snow, fill the two halves of the mold to the edge and press them together. If you're using powdered snow, bury the mold in it, then push it repeatedly between each other, thoroughly compacting the snow in the mold each time.

You can try rotating either half of the mold a few degrees around its vertical axis to help the snow come off the mold or remove any snow that's stuck between the edges. Gently squeeze either half of the mold to demold the snowman.

If your snow is stuck in the mold, try using silicone oil as a release agent.

You can do it onHereObtain the model of the hat.