See images for slicer settings and material.

Fully reversible mod! No drilling or cutting of the pedals.

Notes: The sleeve and collar are printed using a .25mm nozzle. The support bracket is mounted onto the pedal column's existing two uppermost M5 threads. So, remove those M5 screws to fit the bracket. A M4 x 55mm Hex setscrew replaces the existing clevis pin.

Very Important Note: The stroke of the damper is only a few millimeters longer than the pedal travel. To prevent damage to the pedals you must center the damper so it does not stop the pedals from moving before the end of their travel. Only the existing rubber end stops should do that.

Another Very Important Note (last one, I promise): Do not over tighten the M4 Nylock nut onto the clevis. Doing so could damaged the clevis. Just tighten enough to remove any end float.

Parts required and some suggested links...

1 of Damper https://www.amazon.com/dp/B07MQ9MYCV?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2

1 of M4 x 55mm Hex Setscrew

1 of M4 Nylock Nut

2 of M4 Washers

2 of M5 x 20mm Hex Tapered Setscrew https://www.amazon.com/dp/B06Y3X1J7V?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_10&th=1

1 of M8 x 25mm Hex Flat-Head Setscrew https://www.amazon.com/dp/B0FR2SRZ16?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_6&th=1