Project: gumdan.hfp
Print with a layer height of 0.08mm and a 100% infill rate, and the height of the base layer is 0.16mm

The model's dimensions are 121.46x172.37mm.
You can use a higher layer height for printing at a minimum depth of 0.48 mm or less
The maximum depth is 2.2mm, and the actual depth is 2.1mm.

Consumables used:
PLA PolyLite Black, Transmission Distance: 0.3
PLA PolyTerra military blue. Transmission distance: 0.3
BambuLab PLA Basic Red, Transmission Distance: 5
PLA Universal Blue, Transmission Distance: 2
BambuLab PLA Basic Grey, Transmission Distance: 2
BambuLab PLA Basic Beige, Transmission Distance: 8
This printer uses six unique consumables

Switching instructions:
Starting with black
Switch to military blue on the 8th layer
Switch to red on the 11th layer
Switch to medium blue on the 15th layer
Switch to gray on the 17th layer
Switch to beige on the 21st layer