Printing Instructions:

I printed this using PLA with 0.2mm layer height. Print the following:

• (1x) Top Plate
• (1x) Bottom Plate
• (3x) Posts
• (6x) Clips

Assembly Instructions:

1. Push 3 printed clips into the bottom plate. Push until they click. You may have to push pretty hard.
2. Push 3 posts onto the 3 clips in the bottom plate. Again, push until they click. The posts are symmetric. It doesn't matter which end is attached to the bottom plate.
3. Push 3 remaining clips into the top of the 3 posts. Push until they click
4. Push the top plate onto the three posts. Again, push until all of the clips click.