Use a 100% infill rate, a layer height of 0.08, and a base layer height of 0.16 for printing.

It is recommended to set the retraction to 0.6 mm.

Due to the availability of five consumables, a pause was introduced on the 22nd floor.

When this pause occurs, replace the PLA filament in the fourth position of the AMS with white PLA and continue printing until the end.

Consumables used:

Bambulab PLA Basic Black, with a transmission distance of 0.6 meters.

Bambulab PLA Basic Blue has a transmission distance of 4.0 meters.

Bambulab PLA Mate Lilac Purple, with a transmission distance of 2.0 meters.

Bambulab PLA Basic Beige, with a transmission distance of 8.0 meters.

Bambulab PLA Basic Jade White has a transmission distance of 5.0 meters.

Replacement of consumables:

Starting with black.

Change it to blue on the 8th floor.

Change it to purple on the 12th floor.

Change it to beige on the 18th floor.

There will be a pause on the 22nd floor.

Replace the PLA filament in the fourth position of the AMS with white one.

I kept using white ink until the end.