Made this handly little holster for my airpods. I have to admit this is the first model I have ever published anywhere, so please provide feedback if you have any. I had a little silicon case with a clip, but wanted something that could clip to my belt or pants. The airpod holster is not super tight and rattles a little, but i liked it with a little looser fit so when taking in and out it wouldn't scrath the case. I printed at 20% infill, in regular PLA, supports touching buildplate and everywhere. Had no issues removing supports and it prints in a few hours. Hopefully someone else enjoys this practical print!

Print instructions

Printed using regular PLA at 185 degs, heated bed at 50 degs.
Layer height = 0.2
20% infill
Print speed was at 40mm/s
Used a skirt at the buildplate
Printed on an AnyCubic Mega-S