I created this set of Hueforge bookmarks so that all four bookmarks can be created with the same layer settings at once. This print uses six colors, but due to Hueforge's layered printing, you can still print using a single AMS or without AMS.

If you don't have an AMS, you just need to replace the filament manually every time it needs replacing. If you only have one AMS, the process is a bit more difficult.

Cut the model normally, but add a pause at the 11th layer (0.96mm) before the color turns orange, to swap one of the two completed colors (light blue, dark blue, or black) and swap orange and white. Before starting the print, you need to decide which slot to replace with which color, so don't forget the slots you've chosen for orange and white.

How to print

It all started with black

Switch to dark blue on the 6th floor

Switch to blue on the 8th floor

Switch to red on the 10th floor

Switch to orange on the 12th floor

Switch to white on the 20th floor

The filament I used

Black - Duramic PLA Black

Deep Blue - Bamboo Basic Blue

Blue—the blue of the People's Liberation Army cadets

Red - Inland PLA + True Red

Orange - Mika 3D PLA Orange

White - Overture Matte PLA White