I only have made a four dart mold of the tight fitting 3 ring model, if you want other models as a four dart mold from the original model then comment which one and I will get it done as soon as possible!

To use the four dart mold push the darts bottom side down into the mold then, either wait 12 hours or use a hair dryer to heat it up, I found that 35-40 worked for the hair dryer I was using. Wait until the outside of the mold is at room temperature then pull then out by the head.

Pro tip #1 use needle-nose pliers to hold the mold while it's being heated

Pro tip #2 If a newly bambooed (is this a word?) dart is really stuck the try pushing on the bottom of the stuck bambooed dart

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 V2

Resolution:

.2

Infill: 

Doesn't matter

Filament: Overture Petg Black

Post-Printing

I used a pocket knife to clean up the inside probably from using PETG.