Adapted from:https://makerworld.com/en/models/677815-180deg-bambu-lab-x1c-door-hinge-v2#profileId-1492725
 

This is a modified door designed to accommodate an 11 × 14-inch plexiglass panel
 

Print with SUNLU PETG

How to install it:

1. Print all the parts. I suggest printing the two pillars of the door first, the one in the top-left corner and the one in the bottom-left corner.
2. Remove the support.
3. Slide the components into the plexiglass.
4. Glue the corners
5. Print the hinges to be installed on the machine - I trimmed some support material from the hinge surface to ensure a good fit. I provided cutting/spacing variants of 1 mm and 2 mm.
6. Measure ten times and glue once—don't make the same mistake I did. :)