Multipiece Halo ONI logo without lettering

Creality

Ender 5

No

No

0.2mm

I use Cura slicer, here's the basic settings I used on my Ender 5 Plus.

20-30mm/s gave me the best results, YMMV

1 wall, ironing on, disabled "union overlapping volumes"

As designed the model is 90mm in diameter and 1.75mm tall.

Designed to be press fit and held together with a little bit of cyanoacrylate/superglue.

It was designed to be used on the plastic engine cover on the right hand side of a Yamaha FZ/MT-09. With a little notching with a razor blade it should fit snugly.

Of course however, you can use it for whatever you want.