This GPS module case is part of the Raspberry Pi-based open-source data collection project. More information can be found at the Github Repository link below:

https://github.com/hleve/rpi_data_collection

This module is intended to act as a sensor module that will connect to the main computing module through the GPIO pins. In its current state, this module is intended to be mounted to the brim of a hat via the cap with a clip. Alternatively, the module can be mounted to a different surface using the plain cap. The cap with GPIO pin holes is sized for Dupont wires to attach to the five GPIO and can be modified for different pin locations.

The case for the Raspberry Pi Zero and Pi Sugar battery module can be found here: https://www.printables.com/model/1046800-raspberry-pi-zero-and-pi-sugar-battery-case-open-d

This project can be printed in PLA, but for better UV resistance for outdoor use, ASA is the recommended material.