all credit goes to @ChrisBorge

I felt strongly compelled to make the model. Not sure why.

Video: 

BOM:

-120mm fan 25mm thick
-2x m4*50mm
-12x m3*8mm strong magnets
-2x m5*20mm bolts
2x 20mm * 4mm diameter springs
Superglue
Paint for eyes if you dont have a multicolor printer
10mm charcoal filter material

not technically required but silicone spray for the ball joints will help them articulate properly.

Most print orientations pretty obvious, limbs a bit tricky. Will need support, the lay on face tool will be your friend. A set of picks is very useful for support removal.