Added some ridges to allow for better grip with gloves or if your spring is stiff. Also added text to the front which says GLOCK so you can differentiate between this and other GBBP mag loader tools you might have.

Some adjustment might be needed of the grip ridges overhang too much.

Tips for use: Pull the spring of your down slightly and then put the front notch of the tool in the gap created, then bring the back of the loader down so that the tool is level, then pull down to the bottom.

Credit to berenyi and Kubard5 for the original designs.

Print Settings

Rafts:

No

Supports:

No

Resolution:

~0.15

Infill:

20%

Filament: your preferred PLA is fine

Notes:

I'd recommend 3 walls as the rear side is quite weak at low infill. 2 walls is probably fine if you're printing at 30% infill or higher.

Category: Sport & Outdoors