Just a small dispenser for gadgets and doodads. The print is meant to be side mounted against a wall, and comes with three premade screw loops on either side. 

This dispenser is meant for dry items. There is a slit along either side so that the amount of a dispensed item left inside the container can easily be seen. There are two openings in the dispenser: the top one is meant as a reloading/stocking opening, whereas the lower door is where items will be dispensed.

When mounting, please make sure the top screws are level with each other. The bottom of the dispenser should have a 20 degree tilt, to encourage better dispensing mechanics. The lids use cone shaped connectors, and should be able to snap in place. The larger flap is for the top, the smaller one for the lower door.