I needed this since mine broke, if you find it useful print it and leave a like!

This is specifically for this smartwatch:

https://amzn.eu/d/6njvSfc

But I believe you could use it for others as well.

I printed it in PLA and as for now it's holding on, if I see that it still breaks easily I will try with other materials and update you here.

In order to place it I advise the following method:

• place the metal rod and the clip in place
• put one side of the rod in one hole
• widen the 3D ptinted buckle with a little strain
• put the remaining side of the rod in the other hole

I imagine it would be better in PETG but I only had it red and I preferred something less visible.

If you have some of these laying around drop it here :)

Have a look at my other models and if you need anything write in the comments.