Type 2 case for the Odroid H3/H3+.

Hardware required:

• 4x M4 nuts and bolts for attaching the fan and the guard
• 4x M3 bolts for attaching the top to the bottom
• 4x M3 brass insert
• 92mm computer fan
• Some dust filter media
• A switch (if required). This design has a 10mm hole in it for a switch, but it should be easy to modify if required. Behind the switch is plenty of space.

Make sure to install the fan so it sucks air from the top and blows it out the bottom. Otherwise the filter won't do much good :)

Prusa

i3 MK4

No

No

I'd advise to use PETG/ABS. PLA can become soft at the temperatures the Odroid could run at.