Small stabilising model to prevent the USB stick being knocked during printing.

Anycubic

Photon

No

No

Any

none

Can easily be printed as provided either using UV resin, or with FDM Filament.

It is designed to be used with a USB right angle converter so the USB stick is Vertical rather than horizontal thereby reducing the chance of knocking it while printing.

The two indents are designed to hold small rare earth magnets about 6mm X 2mm. They are positioned so they connect to the two screws either side of the USB port and then provide a firmer position against the printer. Additionally, the back of the model reaches to the ground to provide additional stability.

Designed in TinkerCad (hence the blocky nature of the model!)