Use this spacer to raise the top cover of your Elegoo Mars2, 2Pro etc to bring in the power cord to run an internal heater fan or other without drilling a hole thru your cover. The spacer is about .6 inches tall with a mouse hole cutout at the left rear corner for a .25 inch diameter cable. Hotend set to 210 and the PEI bed set to 65 and NO parts cooling fan. You can use a wrap of black electrical tape to connect it to either the top cover or the printer.

Enjoy!

Prusa

i3 MK3

No

No

.2mm layer with 2 outer walls

15

Use this spacer to raise the top cover of your Elegoo Mars2, 2Pro etc to bring in the power cord to run an internal heater fan or other without drilling a hole thru your cover. The spacer is about .6 inches tall with a mouse hole cutout at the left rear corner for a .25 inch diameter cable. Hotend set to 210 and the PEI bed set to 65 and NO parts cooling fan.

Enjoy!