An accessory that can be attached to a USB cable or memory to make it easy to pull out.

If you pinch the shark's fin and nose tightly, the USB plug will pull out.

Insert the tail into the body, repeat the insertion and removal, and when it moves smoothly, insert it into the USB cable, etc.

This data is fine in my printing environment, but if the tail is too tight, try printing at a slightly reduced size.

If you don't want the remover to come off the cable, you can use a rubber band as shown in the picture to make it a little better.

No

Doesn't Matter

0.2mm

100%

I print with a 0.4mm nozzle