Easy to print iPhone stand that takes advantage of IOS 17 Standby Mode using your existing Ravpower 10W Magsafe wireless charger. Charger will fit perfectly without any modifications. Recommended to print with front facing down using supports. Supports easily snapped off from circular lip.

Print takes approx 2 hours on Ender 3 with regular quality 200 filament, 50 bed temp.

Charger used:
Ravpower 10W Wireless Charger
Model: RP-WC012

Used Ravpower charger because it does not heat up as much as official Magsafe charger making it ideal for a overnight bed side charger, and its magnetic hold is good. Regular iPhone Pro was used for demonstration, but Pro Max should work due to extra space below Phone as pictured.

Ender 3

No

Yes

Regular

Standard 20%

Used supports printing with front facing down. Supports were just for the circular lip, and easily removed by starting where the notch is, and pulling off.

gcode file uploaded is configured for Ender 3 printer using Matchbox black PLA at standard print quality.