This device is to help load multiple 8mm diameter capsules at one time. There are three pieces. The bottom holds the big part of the capsule. The middle section can be used to hold a few capsule tops to put them together all at once.

To use, put the middle piece on top of the bottom piece. Separate the capsules and put the larger piece into the bottom, opening up. Put the top piece on top and load your powder, spreading it around and gently shaking it. Once capsules are filled, remove the top and middle sections. Load a few of the smaller capsule tops into the bottom of the middle section with the opening facing down. Gently lower the middle section onto the filled capsules, carefully aligning the capsule tops with the bottom. Continue this part until all the capsules of complete.

Go Big 3D Genesis 8

No

No

0.6mm

100%

This model was designed to be printed with a 0.6mm nozzle. You can use PETG or PLA.