A small print to collect my Wanhao tools so I can stop look for them. It is designed to use one of the screws in the top panel.

Sorry for the dark images, bad light in the room.

The version 2:
Added thicker base because of the small tool doesn't get the support it needed and when the hole got bigger (due to wear and tear) it fall off easier, now it will hang straight. Also made the hole smaller so it could be screwed in place instead of hanging of the screw.

V1:
Natural PLA 1.75
ReplicatorG settings {
Layer Height: 0.2 mm
Number of Shells: 0
Feedrate: 40mm/s
Travel Feedrate: 55mm/s
Print temperature: 215
}

V2:
Natural PLA 1.75
Simplify3D settings {
Layer Height: 0.1
Hot end temp: 230°C
Bed temp layer 1-3: 80°C
Bed temp layer 4-: 0°C
}