Summary

EDIT 1/1/2023 - I no longer use the O3 on the SO v4, but I'll leave this up in hopes that it helps someone else. It was a lot of fun to design and test. :-)

This is a camera mount for the DJI O3 Camera in a Source One v4 / HD. This mount has limited props in view and the standoffs are not in view.

New install method:

It requires 2x 10mm standoffs (bottom) and 2x 5mm standoffs (top), as well as 2x 36mm (longer or shorter, depending) M3 bolts. You will need one M3 nut at the end, on the underside of the quad.

The mount measures 15mm.

Please ensure the front standoffs are securing the frame, as they are now acting together as your front standoff. The side camera panels should be locked in place and the top/bottom frame panels should be parallel once secured, with 30mm between them.

The camera holder frame portions must be cut back to accommodate the mount, and it is highly recommended that these be used for frame stability.

I was very particular about jelly / vibrations / abnormalities in the camera mount, and am very happy with how it performs with and without EIS (RockSteady) enabled. More information on this is here: https://support.dji.com/help/content?customId=en-us03400007215&spaceId=34&re=US&lang=en

Mirror horizontally in your slicer for the other side.

I would recommend using a bumper of some sort as well, I have one here:
https://www.thingiverse.com/thing:5687647

Please print in TPU

The matching VTX mount is here:
https://www.thingiverse.com/thing:5687632

Hopefully the Source One will be updated to accommodate the O3 and this won't be needed anymore. :-)