Holder for PT Level
hinge17cell
AIで類似品を検索
印刷プロファイル(0)
モデルファイル(0)
0
0
0
公開日時:2026-02-15 00:06:18
0
0
000説明
モデルソース
レビュー(0)
I have a cistern and use a PT Level to monitor it (www.ptlevel.com) and wanted a decent way to hold it (other than 2 sticks haphazardly stuck in the ground) . The cap is 170mm across.
I have uploaded version 3 as version 2 the bars finally broke off. I made it a little shorter and added some support to the bars so they are not flimsy anymore.I also changed the following: increase fill to 50% Wall thickness was 1.6 speed was 60 Had Feline printing supervision (see photos)
Print Settings
Printer Brand:
Prusa
Printer:
Prusa Clone
No
Supports:
No
.2 layer height
Infill:
30%
Notes:
I used a .8 nozzle and .2 layer height with .8 wall thickness and it seems sturdy. I had print speed set to 70 but had to slow it down when printing the angle as well as the thinner parts at the top. Nozzle heat was 240 and bed was at 85 printed on Polyimide tape (PetG loves this stuff)
モデルソース
オリジナルリンク: 詳細を見る
CC-BY