Printing Parameters : 

- print at 0.2mm layer height to make some overhangs work properly
- don't use supports

Assembly : 

- insert 4 m3x4 heat inserts in the holes surrounding the fan inlet of the top half
- insert 4 m3x4 heat inserts in the bottom holes of the bottom half
- use a 40x10mm fan and screw it to the inside of the top case, use screws with a low head height (~1mm)
- in order to power the fan you will need to provide you own solution (for example DuPont cables drawing 5V from the 40-Pin Connector), as the MBa8MP-RAS314 doesn't come with any other accessible headers
- to assemble the case place the MBa8MP-RAS314 in the bottom half of the case, add the top half and screw the case together using 4 m3x40 screws