These are adapters for ARC Jeep Wrangler door hangers to allow aftermarket tube doors to be hung on a wall and safely stored while not in use. These doors are the Rugged Ridge tube doors but others may fit. The diameter of the tube holder cradle is 50mm which should work for anything up to 2". The adapters have a bottom slot which fits over the outer lip of the hanger and by centering the cradle over the lip it hangs the doors further away from the wall. The print time was 36 hours with 50% infill but I think it can be shortened significantly by using a infill of 20-30%. 50% was overkill.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.2mm

Infill:

Filament: Amazon PLA

Category: Organization